Month: November 2018

Climax mask and climax filter | mask | Filter

CLIMAX MASK, MOD 761 AND CU-MAX FILTER, MOD 760 The Climax mask mod.761 and Climax filter mod. 761 set has been designed taking into account the essential requirements applicable to it of Royal Decree 1407/1992 and its later modifications based on applying the relevant sections of regulations UNE-EN 140 UNE- EN 141 and UNE-EN 143.

Maintenance Safety

there is no voltage potential in the molten bath. If molten metal were to touchthe coil, the ground leak detectorprobe will conduct current from the coil to ground. This will be detected by the ground detector module and the powerwill be shut offto stop any coil arching. This also prevents high voltage from being carried

Foreword and safety precautions

NOTICE This manual contains proprietary information that is protected by copyright. All rights are reserved and no part of this document may be photocopied or reproduced in any way without the prior consent of Inductotherm (India) Limited. Information contained in this document is subject to change without notice. Inductotherm (India) Limited makes no warranty of

Furnace maintenance

Operation of the furnace maintenance should be in accordance with the procedures described in individual system VIP instruction manuals, bulletins, or data provided with the power supply used. Observe all precautions in the Foreword section of this manual. 1. CHECKOUT The following checkout procedure should be carefully followed prior to operating the furnace: a. Inspect the

furnace maintenance checklist

1. PERIODIC MAINTENANCE CHECKS. Duraline furnaces require very little routine maintenance. However,systematic scheduled attention to general inspection, cleaning, and adjustments can prevent equipment failure and loss of production time. The following maintenance schedule is suggested as a guide for this procedure. WARNING :- Do not perform any maintenance on the system with power on. Place cabinet

Hydraulic System

Hydraulic Power Pack The Power pack consists of an oil reservoir, a pump driven by an electric motor, filters pressure gauges and valves to control the flow or pressure of oil. It is designed to be used in a harsh foundry environment and should provide years of service if properly maintained. That’s why we wish

INSTALLATION AND MAINTENANCE INSTRUCTIONS FOR AIR & HYDRAULIC CYLINDERS

GENERAL PRECAUTIONS Hydraulic Cylinders which have been in storage for some time should be lubricated and cycled several times before they are installed on machines and subjected to actual working loads. Excessive break-loose and cycling pressures indicate the cylinder may have been damaged during shipment or storage. Costly installation and removal time can be eliminated

HIGH FREQUENCY CAPACITOR

(1). SAFETY NOTICE The objective of these instructions is to help make capacitor users aware of application and handling practices which will aid them in the use of power capacitors. The guides cover good practices in receiving, handling, installing, field-testing and disposal of power capacitor unit. The guides do not addross themselves to the requirements

Test procedur || Start Up

(1) GENERAL This section covers test procedure and start-up requirements for tho VIP system The actual procedure is usually performed by INDUCTOTHERM service engineer It is recommended that customer maintenance and operating personnel assist in this operation in order to complete. the tests quickly and gain experience in operating the unit during a melt cycle